Guest bathroom renovation with vinyl in 5 steps

In the following video we show the guest toilet renovation with adhesive vinyl in 5 simple steps. The effort remains as low as possible, because we use the old tiles as a base. Thus, the toilet renovation is possible without large construction site. These are the important steps for the renovation of the guest toilet and adjoining corridor with adhesive vinyl:

1.       Everything must be out of the way to prepare

Empty the guest toilet. Remove bothersome clothing, adhesive residue and silicone. Remove dirt and grease with basic cleaner. Glue off any edges you do not need to fill. The vinyl plank flooring comes perfect here.

2.      Prepare wall surfaces and edges for bonding.

Using cement screed, level the wall tiles completely. With this you prepare a perfect result for glued vinyl. Then set aluminum corner profiles for the thickness of the planned adhesive vinyl. Then fill the profiles flush in the second pass.

3.      Prepare floor space and pre-wall installation Clean and prime

Since the adjoining corridor gets the same vinyl, we adjust the height with leveling compound. Then you can do the installation for the cistern. After the cladding fills everything flush. Grind off the last bumps and vacuum.

4.      Stick vinyl to the walls Apply

The contact adhesive on both sides to the substrate and vinyl backing with a roller or brush is the basic. The pre-cut vinyl planks are already aligned when gluing. With the palm of your hand press the planks. With the vinyl plank flooring Canada this is the perfect deal now.

5.      Stick vinyl to the floor Shorten

The frames for floor laying are important. Clean the floor again. Lay out the vinyl planks over the entire surface and cut completely. The pre-cut vinyl planks are then glued as far as you can apply glue. Do not forget to roll on the planks when freshly inserted. Finally, only the sealing of the joints with silicone remains.